It would be good if there was a way to add startup parameters to the Start-service sshd powershell command and read those messages in the Powershell session. Most Unix-based operating systems use systemd, System V. the event viewer does not contain those messages). The sshd daemon by OpenSSH provides the SSH server service for most platforms. ![]() Figure 1: Restart SSHD Services for Windows. ![]() what you get by starting manually with -d, but even if I add the -d option to the Windows GUI which allows to specify startup parameters for a service, I am not sure where I should be reading those messages (i.e. Select the Extended tab at the bottom Select Georgia Softworks GSWSSHD service Click Restart the service. I would like to understand better what is going on by reading the debug messages of the sshd daemon, i.e. Type the following to go to your install directory (by default, it is C:Program. Basically, if I start the service manually by running C:\Windows\System32\OpenSSH\sshd.exe, everything works fine, but when I start the service through the Windows GUI or Start-service sshd from Powershell, I am not able to connect (I get a publickey denied - I have disabled password logging in the configuration file, so the problem might be a permission issue when trying to read the authorized_keys file). To set up SSH Server: Open a command prompt by using Start -> Run -> cmd. ![]() Immediately SSH tells you that the host was permanently added and then asks for the password assigned to the username. I have a very strange problem trying to make the OpenSSH server that ships with Windows 10 working fine. The first time you connect to a SSH server, it will ask for permission to add the host.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |